Echo Bear Cat 70385 - Manual (Page 24)

Page 18 Bear Cat Chipper Shredder Operator’s Manual
ASSEMBLY INSTRUCTIONS (ALL MODELS EXCEPT MODEL 70580 & 70580S)
Section
2 Assembly
Your chipper/shredder may arrive totally or partially assembled. If your machine arrives partially assembled, you may need
to perform the steps in this section.
(Parts not shown actual size)
A B C
Fig. #15
To prevent personal injury or property damage: Shut off
engine, disconnect spark plug wire, remove ignition key
and make sure that all moving parts have come to a
complete stop, before servicing, adjusting or repairing.
WARNING
2. Install the hopper handle to the hopper assembly using
(4) 5/16” X 3/4” bolts, (4) 5/16” nylock nuts and (4) 5/16”
flat washers as shown below. (The hopper handle is not
used on model 70580 & 70580S).
STEP # 1: INSTALLING THE HANDLE
1. Remove the chipper/shredder and hopper assembly from
the shipping box and pallet.
Tools Needed:
(2) 1/2" Open end wrench
or adjustable wrench
(1) 13/16” Socket and
ratchet
A
B C
D
E
ITEM PART NUMBER DESCRIPTION QTY
A 15003 BOLT, 5/16" X 3/4" HEX HEAD 4
B 15250 WASHER, 5/16" FLAT 4
C 15356 NUT, 5/16" NYLOCK 4
D 71717 HANDLE, RENTAL HOPPER 1
71788 ASSEMBLY, NARROW HOPPER (MODEL 70050 ONLY) 1
70982 ASSEMBLY, WIDE HOPPER (ALL OTHER MODELS) 1
PARTS LIST
E
A
B
C
D
E
ITEM PART NUMBER DESCRIPTION QTY
A 15003 BOLT, 5/16" X 3/4" HEX HEAD 4
B 15250 WASHER, 5/16" FLAT 4
C 15356 NUT, 5/16" NYLOCK 4
D 71718 HANDLE, RENTAL HOPPER 1
71769 ASSEMBLY, NARROW EUROPEAN HOPPER (MODEL 70050S ONLY) 1
71775 ASSEMBLY, WIDE EUROPEAN HOPPER (ALL OTHER MODELS) 1
EUROPEAN HANDLE INSTALL
E
Fig. #16