Daily checklist for the dr log splitter, End of season and storage – DR Power Dual Action 15-Ton Gas (Aug 2011 - Present) User Manual

Page 40

7 5 M E I G S R O A D , P . O . B O X 2 5 , V E R G E N N E S , V E R M O N T 0 5 4 9 1

276141A

Daily Checklist for the DR LOG SPLITTER

To help maintain your DR LOG SPLITTER for optimum performance, we recommend you follow this checklist each time you
use your Log Splitter.

[ ] Check the Engine Oil and Gas Tank level.
[ ] Check that Engine is clean of debris.
[ ] Check the general condition of the Log Splitter, e.g.; Nuts, Bolts, Welds, etc.
[ ] Check Hydraulic Fluid level and fill as needed.
[ ] Check Tire Pressure and wear.
[ ] Check Hydraulic Hoses for cracks or wear.
[ ] Check the Frame for wear and damage.
[ ] Check the Wedge for tightness, nicks and wear.

End of Season and Storage



Change the Engine Oil.



Clean or replace the Air Filter.



Check the Wedge for nicks and wear. Sharpen as needed.



Grease bottom surface of Slide Rail.



If your DR DUAL-ACTION GAS LOG SPLITTER will be idle for more than 30 days, we recommend using a Gas Stabilizer. This will
prevent sediment from gumming up the Carburetor. If there is dirt or moisture in the Gas or Tank, remove it by draining the
Tank. Completely fill the Tank with fresh, unleaded Gas and add the appropriate amount of Stabilizer or Gasoline Additive. Run
the Engine for a short time to allow the Additive to circulate.



Clean the exterior of the unit to remove all dirt, grease, and any other foreign material. Clean dirt and debris from the Cylinder
Head Cooling Fins and Muffler area of the Engine. To prevent rust, touch up painted surfaces that have been scratched or
chipped.



Be sure all Nuts, Bolts, and Screws are securely fastened.



Remove the Spark Plug(s) and pour about 1 ounce of Motor Oil into the Cylinder hole. Replace the Plug(s) and crank the Engine
over a couple of times using the Pull Cord, or the Electric Starter (for Electric Start Machines). This will coat the piston and seat
the Valves to prevent moisture buildup.



If possible, store the Log Splitter in a dry, protected place. If it is necessary to store the Log Splitter outside, cover it with a
protective material (especially the Engine). For Electric Start Model, store the machine in a dry environment with temperatures
between +40°F (5C) and +95°F (+35C). Make sure the storage temperatures will never be outside of these limits. The lower the
storage temperature is within the specified temperature the better as the Battery will discharge more slowly at low temperatures.
If it is necessary to store the Log Splitter outside make sure to disconnect the Battery and store it in an environment as listed
above. Make sure the disconnected Battery Terminals are not resting on any surface that may be prone to collecting water, snow
or any other liquid as this may cause damage to the Terminals and to the Battery when reconnected.

Before performing any maintenance procedure or inspection, stop the engine, wait five (5) minutes to allow all parts to cool.
Disconnect the spark plug wire, keeping it away from the spark plug.