DR Power Dual Action 15-Ton Gas (Aug 2011 - Present) User Manual

Page 11

Note: The Slots of the Engine Mount are for Gas Engine mounting and the round

holes are for Electric Motor mounting.

16. Position the Engine onto the Bracket and align the Engine Base holes with

the slots of the Bracket (Figure 11).

17. Electric Start only: Route the Harness down to the front left corner of the

Engine and connect the green wire ground Terminal of the Harness to the
Engine mounting flange with a Bolt, Flat Washers (top and bottom) and
Locknut using two 1/2" Wrenches (Figure 12).

18. Install the four sets of Bolts, Flat Washers (top and bottom) and Locknuts

using two 1/2" Wrenches to secure the Engine to the Mount (remaining
three sets for electric start).

Note: Remove protective Caps as needed for the following Hydraulic Hose

connections.

19. Install the Elbow Hydraulic Fitting into the Tank assembly by hand until it

cannot be turned any more with your hand. If needed, turn the Elbow back
to align it parallel with the ground and facing out (Figure 13).

20. Tighten the Elbow Jam Nut against the Tank with a 7/8" Wrench.

21. Use Wire Cutters to cut the Cable Ties holding the Hydraulic Hoses

together.

22. Install the Fluid Suction Hose onto the Pump and Tank fittings using a 7/8"

Wrench.4

23. Slide the Sheathing over one of the Pressure Hoses and secure it to the

Hose with a Cable Tie near each end (Figure 14).

Note: When installing the following Hose fittings they should be tight, but try not

to over tighten. Start with a snug fit and if leaking is detected then tighten a
bit more until no leaks are detected.

24. Install the Hose with Sheathing to the Control Valve (long elbow end) and

Pump using a 7/8" Wrench.

25. Install the Fluid Return Hose (long elbow end) at the Control Valve and the

top of the Tank using a 7/8" Wrench (Figure 15).

Engine
Hardware

Figure 11

Engine
Mount

Wire
Harness

Figure 12

Hole

Ground
Terminal

Suction
Hose

Figure 13

Elbow

Jam Nut

Pump

Pressure
Hose

Figure 14

Sheathing

Long Elbow

Pump

Control
Valve

Cable Tie

Fluid Return
Hose

Figure 15

Long Elbow

Tank