DNF Controls SW32PS_Port_Switcher - Manual (Page 7)

Page 6 of 24 SW32PS RS422 Port Switcher
4. OPERATION
a. MAKE A ROUTE
1) Press
[FROM]. The FROM indicator will turn on.
The first line of the display shows you the currently selected FROM connector
(PORT1-32).
Turn the Wheel until the desired FROM point is displayed.
2) Press
[TO]. The TO indicator will turn on. Second line of the display shows
you the currently selected TO connector (PORT1-32). Turn the Wheel until the
desired TO point is displayed.
3) Press
[TAKE] to route the FROM input to the TO output.
NOTE: No Route is made until [TAKE] is pressed.
b. VIEW THE ROUTES
1) Press
[VIEW]. The VIEW indicator will turn on.
2)
Turn the Wheel to scroll through all ports that are displayed on the first line of
the display.
3)
The second line of the display will show the port(s) connected to the selected
port.
c. SETUP GANG
1) Press
[FROM]. The FROM indicator turns on.
The first line of the display shows the selected input port.
2)
Turn the Wheel to select the source port.
3) Press
[TO]. The TO indicator turns on.
The first line of the display shows the selected output port.
4) Press
[GANG]. The GANG indicator turns on.
5)
Turn the Wheel to select the destination port.
6) Press
[TAKE] to route the selected input to the selected destination.
The third line of the display will show “PORT(X) Added.”
7)
Repeat steps 5-6 to add as many routes to GANG.
8) Press
[ESC] when done.