DNF Controls DMAT-MAV - Manual (Page 8)

D D M M A A T T - - M M A A V V 8 8
M ARK A C UE P OINT
Press [MARK] to mark the Recorder’s time into the Cue Point.
S EARCH TO C UE P OINT
1. Press [NEXT] or [LAST] to search to the NEXT/LAST Cue Point
OR
2. Enter the Cue Point (#0-7) on the numeric keypad; press [RECALL CLIP].
OR
3. Press [SHIFT] + [NEXT] or [SHIFT] + [LAST] to search to the current Cue
Point.
P REROLL
1. Press [ALT] + [LAST] to search to the current time minus the preroll time
assigned in the MENU.
2. Press [ALT] + [NEXT] to search to the current time minus the preroll time X2
assigned in the MENU.
S ET AN IN P OINT
1. Press [IN] to set the IN Point.
The IN indicator on the ST400 will turn on.
The display will show “IN xx:xx:xx:xx ”,
where xx:xx:xx:xx is the saved time.
OR
2. Enter the time on the numeric keypad and press [GOTO].
3. Press [IN] to save the entered time.
S ET AN OUT P OINT
1. Press [OUT] to set the OUT Point.
The OUT indicator on the ST400 will turn on.
The display will show “OUT xx:xx:xx:xx ”,
where xx:xx:xx:xx is the saved time.
OR
2. Enter the time using the numeric keypad and press [GOTO].
3. Press [OUT] to save the entered time.
(If AUTOSAVE is on, clip will be saved automatically when the OUT is set.)
C LEAR THE IN P OINT
1. Press and hold [DEL], then press and release [IN]. The IN indicator will turn
off.
C LEAR THE OUT P OINT
1. Press and hold [DEL], then press and release [OUT]. The OUT indicator will
turn off.
S AVE THE CLIP
Press [SAVE CLIP].
R ECALL AND P LAY THE CLIP
1. Press [RECALL CLIP] to enter CP (Clip Play) mode.
OR
Enter the clip number (#0-399) on the numeric keypad, then Press [RECALL
CLIP].
2. Press [PLAY].
A DD CLIPTO P LAYLIST
Press [ADD ELEM] to add the currently loaded clip to the current playlist.
P LAYOUT P LAYLIST
Press [CUE LIST], then press [PLAY] or move theT-Bar.
P
ROGRAM AND P REVIEW C HANNELS (PGM & PVW CONFIGURATION ONLY )
The PROGRAM output is the AIR feed. Only the [PLAY] and T-Bar SLOMO functions control this
output; all other transport functions control the PREVIEW output.
To switch video to the PROGRAM channel from the PREVIEW channel, press [CUT], [MIX] or [WIPE].