DNF Controls DMAT-MAV - Manual (Page 4)

D D M M A A T T - - M M A A V V 4 4
B. PROGRAM & PREVIEW MODE OVERVIEW
The two MAV output channels gives two views into the recorded material, a PREVIEW view and
a PROGRAM view. The PROGRAM output is the AIR feed. Only the [PLAY] and T-Bar
SLOMO functions control this output; all other transport functions control the PREVIEW output.
The PREVIEW output is used to view marked Cue Points, view clips or playback a camera feed to
find the desired video.
To switch video to the PROGRAM channel from the PREVIEW channel, the [CUT], [MIX] and
[WIPE] functions are used. The duration of the MIX and the pattern and duration of the WIPE are
definable by pressing [EDIT EFFECT].
Figure1B
The GANG mode means that all transport functions apply to both Program and Preview channels,
e.g., press [PLAY] to put both channels in PLAY, move the T-Bar to slomo both channels, press
[STOP] to stop both channels, press [REC] to put both channels into EE mode.
Primary operating modes are:
PLAYBACK Press [PLAY]
EE Mode Press [REC]
CLIP PLAY Mode Press [RECALL CLIP]
LIST PLAY Mode Press [CUE LIST]
FEATURES:
9 8 Cue Points
9 400 Clips
9 12 Play Lists
9 30 Clips/List
9 1 or 2 Camera Operation
DEFINITIONS
‰ Throughout this document, the SONY MAV-555 will be referred to as MAV, MAV-555 or “Video
Server”.
‰ Words surrounded by brackets in bold type, for example, [ENTER], are labeled keys on the ST400.
‰ Words surrounded by brackets in bold italic type, for example, [CLIP], are multi-function SOFTKEYS
‰ [XXX] + [XXX] means hold the two keys down simultaneously.
‰ CP mode is CLIP Play; PL mode is LIST Play