DNF Controls Analyst, RS422/RS232 Tester - Manual (Page 8)

c) The current Analyst ID will be displayed on the 2
nd
line.
Select a character position using the [<<<] and [>>>] keys.
Use the knob to change the character at the selected position.
d)
Press the [NEXT] key to save the new ID and exit to the MENU screen
OR,
Press the [Exit] key to exit without saving the new ID.
The Analyst is ready for use.
D. Analyst Test Modes
MAIN Screen
The Analyst RS422/RS232 Tester
Press key to select test mode:
SEND RECV MON. ADAPT VTR Menu
Sw #1 Sw #2 Sw #3 Sw #4 Sw #5 Sw #6 Sw #7 Sw #8
MAIN Screen
TEST MODES-
Description
SEND Sender Mode is used for testing cables and signal paths.
RECV Receiver Mode is used in conjunction with SENDER mode for
testing cables and signal paths.
MON Monitor Mode is used for testing serial communication problems
between two pieces of equipment.
ADAPT Adapter Mode is used for testing RS232 To RS422 Adapters
VTR VTR Mode is used for testing cables and signal paths with a VTR.
MENU Menu Mode is used for setting up and configuring the Analyst.
Page 4 of 31 The Analyst RS422/RS232 Tester