DNF Controls 4000CL-MAV70 - Manual (Page 7)

7 4000CL-MAV70, 400 Clip Fast Access System, for MAV70
7. LEARN
a.
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by manually
entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
b.
LOAD a clip (see previous section).
c.
Press [SHIFT] + [MARK] to start the LEARN.
The first line of the display will show “Select VTRs:”
The second line of the display will show “Mark-Lrn, ESC-cancel.”
d.
Press VTR [1], [2], [3] or [4] to select the VTR to be learned into the current Cue Point.
If the VTRs are ganged, select one VTR that is part of the Gang. The rest of the Gang
will learn automatically.
e. Press
[MARK] to complete the LEARN.
OR
Press [ESC] to exit without LEARNING.
The ST300 will: LEARN (save) the VTR Number (1,2,3,4), loaded CLIP ID and current
IN time to the selected Cue Point.
8. RECALL
a. Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE].
OR
By manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
b. Press
[LOAD] on the ST300.
The ST300 will automatically load the Learned clips on the Learned VTRs, cue the clips
to the Learned time, then set the Learned GANG mode.