DNF Controls 2034CL-L Vs.3.0 - Manual (Page 9)

9 2034CL-L, Vs.3.0, 300 Clip Instant Access System, Louth Protocol
4. VIDEO SERVER SETUP
a)
Select LOUTH Broadcast communications protocol on the VIDEO SERVER to be
controlled.
b)
If required, assign a serial port on the VIDEO SERVER through which the
ST300 will control it.
NOTE: In LOUTH mode, the VIDEO SERVER O NLY allows Full Record.
(INSERT and ASSEMBLE record modes are disabled.)
Setup is complete.
5. LOAD
a.
Select a VTR by pressing VTR[1], VTR[2], VTR[3] or VTR[4].
b.
Load the desired clip using the CLIP LIST function. (See Section 9, CLIP LIST
FUNCTION.)
c.
Repeat steps a - b until clips are loaded into the desired VTRs.
d.
Set the GANG mode, if required. (Refer to the Function Table for Details.)