DNF Controls 2034CL-L Vs.3.0 - Manual (Page 10)

6. LEARN
a. LEARN ON THE SHOTBOX
1) Press
[LEARN]. The LEARN indicator will turn on.
2)
Select the desired BANK and ShotKey.
3)
The Learned CLIP ID will be displayed on the pressed key.
NOTE: This will overwrite what you have assigned to the key previously.
4)
The ST300 will remember the loaded clip(s), current time and gang
configuration of the active VTR(s).
5) Press
[LEARN] to exit at any time.
NOTE: The [LEARN] key toggles LEARN mode on/off.
b. LEARN ON THE ST300
1)
Select the desired Cue Point by pressing [NEXT CUE], [LAST CUE] or by
manually entering the Cue Point using the numeric keypad.
The selected Cue Point number is shown on the bottom line of the display.
2)
Press [SHIFT] + [MARK] to initiate the LEARN.
10 2034CL-L, Vs.3.0, 300 Clip Instant Access System, Louth Protocol
The display will show:
3)
Press the VTR key desired, [1],[2],[3], [4].
Press VTR:
MARK-Lrn ESC-Cancel
4) Press
[MARK] and the ST300 will:
LEARN (save) the VTR Number (1,2,3,4), loaded CLIP ID and current IN/OUT
time to the selected Cue Point.