Footswitch connector, Setting up an fp-2 foot pedal, Operation of the fp-2 – Digital Audio Labs Livemix CS-DUO Personal Mixer User Guide User Manual
Page 43
LIVEMIX CS-DUO
41
FOOTSWITCH CONNECTOR
The ¼” connector on the CS-DUO rear panel allows connection
of an optional foot pedal accessory. The FP-2 foot pedal allows
you to adjust mix settings or activate the intercom on your CS-
DUO while keeping your hands on your instruments.
SETTING UP THE FP-2 FOOT PEDAL
1.
IN: Connect a ¼” TRS cable to the foot pedal jack on the
CS-DUO. Make sure the cable is a TRS and has Tip, Ring,
and Sleeve. A standard TS or guitar cable will not work with
the FP-2.
2.
A/B Switch: Set this switch to ‘A’ to control MIX A or ‘B’ to control MIX B.
3.
THRU: The THRU connector allows you to connect two foot pedals to one CS-DUO, one for MIX
A and one for MIX B. Use a TRS cable to connect the first pedal to the second pedal and assign
the A/B switches accordingly.
OPERATION OF THE FP-2
The FP-2 foot pedal is simple to use. Each function is controlled by either a TAP or a HOLD on one
of the buttons. A TAP is a short press, less than 1 sec in duration. A HOLD is a long press lasting
more than a second.
1.
TAP BUTTON 1: A short tap on button 1 will select the next channel on the CS-DUO. When you
reach channel 24 it will select the Accessory Channels then cycle back to channel 1.
2.
HOLD BUTTON 1: A long press on button 1 will return you to the ME Group. If a ME Group is
not set up, holding button1 will return you to channel 1.
3.
TAP BUTTON 2: A short tap on button 2 will turn up the volume of the selected channel.
4.
HOLD BUTTON 2: A long press on button 2 will reduce the volume of the selected channel.
The volume of the selected channel will continue to reduce as long as button 2 is held.
5.
HOLD BUTTON 1 & BUTTON 2: A long press on both buttons simultaneously will activate
the intercom feature of the CS-DUO. You will need to hold both buttons down for a full second
before the intercom activates.
NOTE:
The only foot pedal that will
function with the CS-DUO is
the Livemix FP-2. Third party
footswitches will not work.
The FP-2 is available from your
authorized Digital Audio Labs
dealer.