Digital Audio Labs Livemix MT-1 Microphone Stand Mount - Manual

MT-1 USER GUIDE
POLE MOUNT
MT-1-1 rev 1.0
The Pole Mount configuration allows a CS-DUO to mount on a microphone
stand that is already being used on stage, reducing stage clutter and
eliminating the expense of purchasing dedicated stands for personal
mixers.
The MT-1 is compatible with pole diameters between 3/8” to 1 1/4”. This
allows the MT-1 to work with a wide variety of microphone, music and
percussion stands.
Before you begin, locate these features on the MT-1:
1. 2x Threaded knobs (1 3/4” length, 1/4” - 20 thread)
2. 1x Removable V-Clamp piece
3. 2x Captive thumbscrews (thread into CS-DUO)
To attach the MT-1 and CS-DUO to your mic/music stand pole:
1. Loosen the threaded knobs to the point where the V-Clamp can swing
freely.
2. Insert the mic/music stand pole between the V-Clamp and the back of
the MT-1.
3. Tighten the threaded knobs evenly until the MT-1 is fastened tightly to
the pole.
4. While holding the CS-DUO, slide the CS-DUO down the mount so the
back wall of the CS-DUO catches the alignment surface of the MT-1.
5. Still holding the CS-DUO, center it on the MT-1 and thread the thumbscrews into the CS-DUO by hand.
If permanent attachment is desired, the thumbscrews can also accommodate Flathead and Phillips
screwdrivers.
6. Route cables through cable management openings.