DFI EL339-B - Manual (Page 69)

69
3
BIOS Setup
KB Power On Password
Move the cursor to this field and press . Enter your password. You
can enter up to 5 characters. Type in exactly the same password to confirm,
then press .
The power button will not function once a keyboard password has been set in
this field. You must type the correct password to power on the system. If you
forgot the password, power-off the system and remove the battery. Wait for
a few seconds and install it back before powering-on the system.
Hot Key Power On
This field is used to select a function key that you would like to use to pow-
er-on the system.
Onboard FDC Controller
Enabled
Enables the onboard floppy disk controller.
Disabled
Disables the onboard floppy disk controller.
Onboard Serial Port 1 and Onboard Serial Port 2
Auto
The system will automatically select an I/O address for the onboard serial
port 1 and serial port 2.
3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3
Allows you to manually select an I/O address for the onboard serial port 1
and serial port 2.
Disabled
Disables the onboard serial port 1 and/or serial port 2.
Onboard Parallel Port
378/IRQ7, 3BC/IRQ7, 278/IRQ5
Selects the I/O address and IRQ for the onboard parallel port.
Disabled
Disables the onboard parallel port.