DFI EL339-B - Manual (Page 39)

39
2
Hardware Installation
Parallel
S/PDIF-Out Connector
The S/PDIF-out connector is used to connect an external S/PDIF-out port. Your
S/PDIF port may be mounted on a card-edge bracket. Install the card-edge
bracket to an available slot at the rear of the system chassis then connect the
audio cable to the S/PDIF-out connector. Make sure pin 1 of the audio cable is
aligned with pin 1 of the S/PDIF-out connector.
1 5
+5V
Key
SPDIF out
Ground
N. C.