Datalogic Scanning MATRIX 1000 - Manual (Page 35)

INSTALLATION
25
2
2.6 TYPICAL LAYOUTS
The following typical layouts refer to system hardware configurations. However, they
also require the correct setup of the software configuration parameters. Dotted lines
in the figures refer to optional hardware configurations within the particular layout.
2.6.1 Point-to-Point
In this layout the data is transmitted to the Host on the Matrix-1000
 aux serial
interface.
Parameter configuration can always be accomplished using the Matrix-1000

auxiliary interface.
When either Phase Mode or One Shot operating mode are used, the reader can be
activated by an external event (for example a pulse from a photoelectric sensor)
when the object enters its reading zone.
Figure 26 - Point-to-Point Layout
Auxiliary Interface (Local Echo)
External Trigger
C-BOX 100
Matrix-1000™
Local Host
P.S.
PG6000
CAB-600X