beautypg.com

Delta Electronics Network Device DN02 User Manual

Devicenet communication module instruction sheet

background image

DeviceNet Communication Module Instruction Sheet

1. Panel

Appearance: 1) For RS-485 connection to VFD series 2) Communication port for connecting

DeviceNet network 3) Address selector 4) Baud rate selector 5) Three LED status
indicators for monitor. (Refer to the figure below)

2. Network

Wiring:

Picture right hand side below shows rough wire configuration. Refer to DeviceNet

wiring spec for physical wire connection.

3. Mounting

Method:

Picture right hand side below shows how to mount this communication module

onto DIN Rail

SP

Module

Network

Data Rate

ADD1

ADD2

42.0 [1.65]

100.0 [3.

94]

34.0 [1.34]

9

2.

0 [3

.6

2]

4. Power

Supply: No external power needed. Power is supplied via RS-485 that is connected to VFD

series. Six pins RJ-11, which is packed together with this communication module, is
used to connect the RS-485 between VFD series and this communication module for
power. This communication module will perform the function once is connected.

Refer

to following paragraph for LED indications.

5. LEDs Display:

SP: Green LED means in normal communication, Red LED means abnormal.

Module: Green blink LED means no I/O data transmission, Green steady LED means I/O data

transmission OK.
Red LED blinking or Red LED mean module communication is abnormal.

Network: Green LED means DeviceNet in normal communication, Red LED means abnormal

★ Refer to user manual for detail information-- Chapter 5 Troubleshooting.