DFI DT122-SB Manual - Manual (Page 38)

www.dfi .com
38
Chapter 7 BIOS Setup
Chapter 7
MEBx Selection Screen
OEMFLag Bit 2: enable or disable MEBx selection screen.
Un-configure ME
OEMFLag Bit 15: Un-configure ME without password.
AMT Configuration
This section is used to configure the AMT function.
Enable or disable Intel (R)
Active Management Tech-
nology. Note: iAMT H/W
is always enabled. This
option just controls the
BIOS extension execution.
If enabled, this requires
additional fi rmware in the
SPI device.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Intel AMT
MEBx Selection Screen
Un-confi gure ME
Advanced
[Enabled]
[Disabled]
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
USB Configuration
This section is used to configure USB.
Enables Legacy USB
support. AUTO option
disables legacy support if
no USB devices are
connected. DISABLE
option will keep USB
devices available only for
EFI applications.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
USB Confi guration
USB Devices:
2 Hubs
Legacy USB Support
EHCI Hand-off
Advanced
[Enabled]
[Disabled]
 Select Screen
 Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous
Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Legacy USB Support
Enabled
Enables legacy USB.
Auto
Disables support for legacy when no USB devices are connected.
Disabled
Keeps USB devices available only for EFI applications.
EHCI Hand-off
This is a workaround for OSes that does not support EHCI hand-off. The EHCI ownership
change should be claimed by the EHCI driver.
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.