DFI DT122-SB Manual - Manual (Page 26)

www.dfi .com
26
Chapter 5 Ports and Connectors
Chapter 5
SATA (Serial ATA) Connectors
1
7
RXN
GND
TXP
TXN
GND
1
RXP
GND
SATA 3.0 6Gb/s SATA 2.0 3Gb/s
SATA 0
SATA 1
SATA 4
SATA 5
Features
The Serial ATA connectors are used to connect Serial ATA devices. Connect one end of the Se-
rial ATA cable to a SATA connector and the other end to your Serial ATA device.
BIOS Setting
Configure the Serial ATA drives in the Advanced menu (“IDE Configuration” submenu) of the
BIOS. Refer to chapter 3 for more information.
• SATA 0 and SATA 1 support data transfer rate up to 6Gb/s
• SATA 4 and SATA 5 support data transfer rate up to 3Gb/s
• Integrated Advanced Host Controller Interface (AHCI) controller
• Supports RAID 0, RAID 1, RAID 5 and RAID 10
Cooling Fan Connectors
The fan connectors are used to connect cooling fans. The cooling fans will provide adequate
airflow throughout the chassis to prevent overheating the CPU and system board components.
BIOS Setting
The Advanced menu (“Hardware Health Configuration” submenu) of the BIOS will display the
current speed of the cooling fans. Refer to chapter 3 for more information.
1
System fan
CPU fan
1
4
Sense
Power
Ground
Speed
Control
3 1
Sense
Power
Ground