beautypg.com

Dataprobe 8PK-SCS User Manual

Page 9

background image

Model 8PK-SCS

Page 9

Master

E

A

B

C

D

F

G

H

RTS
DTR

A B C D E F G H

Modem
Option

Port

Select

Power

Port Status LEDs

FIGURE 4
Component Location

Relay Status LEDs

1 2 3 4
5 6 7 8

1 3 5 7

2 4 6 8

RTS / DTR Selection

Jumpers JP1 through JP4 allows selection of RTS (default) or DTR as the control lead used for Lead
Control. To access these jumpers, disconnect the power source and remove the top cover of the
8PK-SCS. See Figure 4 for location of jumpers.

Control Relay Connection

Connection to the eight control relays are made using eight RJ11 modular jacks located internally on
the printed circuit board. To access these connections, disconnect the power and remove the top cover
of the unit. (Refer to figure 4, component location) Dataprobe supplies A/C power and communications
switches that can be used with the 8PK-SCS. The pin-outs of the modular jacks are designed to
connect directly to Dataprobe’s relay switches. In some cases a control cable, available from Dataprobe
is required.

Model Description Connect to 8PK-SCS with

K-12A

A/C Power Switch

RJ11 Cord supplied with K-12A

K-515A

4 Outlet Power Strip

Cable Supplied with K-515A

K-AB Series

Communications A/B

Cable SL-K7 Ordered Separately

To connect any other equipment to the relays, the following pin-out should be used:

Pin # Designation

2

Normally Open

5

Common

1
2 NO
3
4
5 COM
6

Figure 5

Modular Jack Pinout for

Relay Connections