Daktronics All Sport CG - Manual (Page 7)

Introduction 1
Section 1: Introduction
This manual explains the operation of the All Sport ® CG (Character Generator). For additional
information regarding the safety, installation, operation, or service of this system, refer to the
telephone numbers listed in Section 4.2.
Important Safeguards:
 Read and understand all instructions, both general and for specific sports.
 Do not drop the control console or allow it to get wet.
 Do not disassemble control equipment or electronic controls of the display; failure to
follow this safeguard will make the warranty null and void.
 Always unplug the control equipment when it is not in use. Never yank the power
cord to pull the plug from the outlet. Grasp the plug and pull to disconnect.
 Do not let any power cord touch hot surfaces or hang over the edge of a table that
would damage or cut the cord.
 If an extension cord is necessary, a three-pronged, polarized cord should be used.
Arrange the cord with care so that it will not be tripped over or pulled out.
 Inspect console for shipping damage such as rattles and dents, and verify that all
equipment is included as itemized on the packing slip. Immediately report any
problems to Daktronics; save all packing materials if exchange is necessary.
1.1 Resources
Figure 1 illustrates a Daktronics drawing
label. The drawing number is located in the
lower-right corner of a drawing. This
manual refers to drawings by listing the last
set of digits and the letter preceding them.
In the example, the drawing would be
referred to as Drawing C-325405.
Reference Drawing:
System Riser Diagram ........................................................................... Drawing C-325405
Daktronics identifies manuals by the DD or ED number located on the cover page of each
manual. For example, this manual would be referred to as ED-15365.
Figure 1: Daktronics Drawing Label