Daktronics AF-3090-89-R,A - Manual (Page 37)

Maintenance &
Troubleshooting
4-12
4.13 Boot Up Initialization Information
Every time the display is powered up, the display will run through an initia lization in which it will
display the following:
1. Output Test (DDDs)
2. Product Name (Galaxy)
3. Display Size (Row x Column)
4. Firmware Number (ED-10134)
5. Firmware Revision (Rev X.XX)
6. COM1 Configuration (C1: V15/RTD)
7. COM2 Configuration (C2: None)
8. Line Frequency (60 Hz)
9. Hardware Address (HW: XX)
10. Software Address (SW: XX)
11. Display Name
12. Modem (If modem is present)
4.14 Replacement Parts List
The following table contains some of the items in this sign that you may need to replace over time.
Many of the parts within the sign also list their part numbers on labels affixed to them.
To prevent theft, Daktronics recommends purchasing a lockable cabinet to store manuals and
replacement/spare parts.
Part Description Part Number
Controller 0A-1146-0035
Signal Converter-wire 0A-1127-0237
Signal Converter-Fiber 0A-1127-0239
Modem in display 0P-1146-0003
Light Detector 0P-1151-0002
Digital Temp Sensor 0P-1151-0003
Fiber Board in Display 0P-1127-0024
422 Surge Protector 0P-1146-0031
Phone Surge Protector A-1527
Thermostat Enclosure 0A-1213-4024
Cable, 40-pin ribbon, 66 inch, Dual Row W-1439
Cable Assy, 6-pin to 6-pin harness 0A-1261-0001
Amber Pixel Strip 0P-1261-0003
Red Pixel Strip 0P-1261-0004
Driver Board 0P-1261-0002
Power Supply – Red 0A-1259-4008
Power supply – Amber 0A-1259-4005
Fan; 110CFM, 115VAC, 17W, 60Hz, 4.5” B-1006
Line Filter Assembly 0A-1259-4003
Manual; Venus 1500 Operator’s ED-12717
Manual; Galaxy Outdoor 89 mm Louvered Signs ED-13288