Daktronics DF-2100 - Manual (Page 49)

Section 9: POS Interface Installation and
Operation
A Point of Sale (POS) interface option is available with DataMaster LED Petroleum Price Displays.
Displays with this option automatically update when product prices are changed in the POS.
Displays with the POS interface option will be supplied with a POS Interface Kit (see table below for
part numbers).
P.O.S. Interface
Type
Interface Kit
Required
Interface Cable Riser Diagram
Gilbarco G-Site 0A-1279-0400 0A-1279-0402 200195
Gilbarco PAM 1000 0A-1279-0452 0A-1279-0229 224628
Allied 0A-1279-0443 0A-1279-0144 215840
Verifone Sapphire 0A-1279-0146 0A-1279-0145 200195
9.1 System Installation
1.
Ensure that the P.O.S. system has a price sign output port. Refer to the P.O.S. manuals to
enable and/or configure the port.
2. Locate the following parts:
a)
POS Interface Kit containing:
i) DataMaster 100 w/POS option (0A-1196-0133)
ii) Wall mounting bracket for DM-100 (0M-200082)
iii) POS Interface Cable (refer to table 7-1 for part number)
iv) POS riser diagram (refer to table 7-1)
b) 10′ cable, DB9 to DB9 (W-1267)
c)
Indoor junction box (0A-1196-0099) for direct wired installations or Radio Interface
junction box (0A-1279-0161) for wireless installations.
d)
Wallpack transformer (T-1118).
3. Mount the wall bracket (0M-200082) to provide convenient storage for the DM-100
controller. When using the wall-mount bracket for the DM-100, ensure that clearance is
sufficient above the bracket to allow the DM-100 to be removed from the bracket with
both cables attached. Also ensure that the POS interface cable will reach from the DM-
100 location to the price sign output of the POS. Fasten the wall-mount bracket if desired.
The DM-100 can be permanently attached to the wall mounting bracket by removing the
two screws in the bottom edge of the DM-100, sliding the DM-100 into the wall mount
bracket, and reinstalling the screws through the slots in the bottom bracket flange.
4.
Mount the junction box (refer to step 1.c. above). Ensure that the DB9 to DB9 cable (W-
1267) will reach from the DM-100 to the junction box.
5. Complete junction box to sign or junction box to radio wiring as shown on the riser
diagram (drawing 200195).
6.
Attach the P.O.S interface cable to the P.O.S price sign port. Coil any excess cable and
cable-tie it out of the way.
POS Interface 41