Daktronics DF-2100 - Manual (Page 34)

26 DM-100 Controller
Petroleum Price Display Startup
To operate the DataMaster Petroleum Price displays, the DM-100 must first be programmed
to the gas price function. Use the [Set Function] key on start-up. Use the following table as a
guide to start-up procedures.
LCD Screen Action
CURRENT
FUNCTION
GAS PRICE Plug the wall pack transformer into a 120 V AC
power outlet and connect it to the DM- 100.
This display appears briefly.
CHANGE
FUNCTION?
PRESS SET
FUNCT This message appears next on the screen.
If GAS PRICE was shown on the bottom line of
the LCD during startup, do nothing. The
controller will automatically default to previous
Gas Price settings.
If a function other than GAS PRICE was shown
on the bottom line of the LCD during startup,
press the [Set Function] key while the second
LCD prompt is displayed.
SELECT
FUNCTION
GAS PRICE
↓↑
Press the arrow up or down keys< ↑↓ > until the
gas price option is shown. Press the [Enter] key
to accept.
The DM-100 handheld controller should now be ready for use. The controller will
“remember” the last function setting, so this step should only need to be done with a new
controller, or one that is configured for different displays. To operate the DM-100, press any
of the keys listed in the following gas price sections.