Daktronics DF-2100 - Manual (Page 37)

Display Status
The Display Status menu item can be used with a bi-directional display setup to get display
status back from the driver. The controller will cycle through various LCD message screens,
illustrated below and on the following page, that show display status. Press [Clear] at any
time to exit the Display Status submenu.
LCD Screen Action
Display status
Get status?
Driver Firmware
version x.x
Current day/time
mm/dd/yy
HH:MM
Last reset time
Mm/dd/yy hh:mm
Current temp
Xx ºf
TEMP SENSOR
OFFSET Xx ºC
Press [Enter] to get the status of the display that is
connected to the DM-100.
The LCD will scroll through the status sent back from
the display. Following is a list of responses:
Firmware Version
This is the firmware version programmed on the host
MASC driver in the display.
Current Day/Time
This is the Day/Time value set in the driver. The time
format used will be 24-hour.
Note: To set the Day/Time, see the "Set Time"
section of your DataTime display system's
operation manual.
Last Reset Time
This time represents the last time the driver was
reset. Note that the time format used will be
24-hour.
Current Temp
This is the temperature read at the display by the
temp sensor. (This value does not include the offset,
if applicable).
Temp Sensor Offset
This is the temp sensor offset value programmed
into the driver.
DM-100 Controller 29