Daktronics KE-1010-7.6-RG - Manual (Page 15)

Mechanical Installation
2-3
1. Before attempting to connect the sections, check their alignment in relation
to each other. If the alignment is off, then you may need to adjust the
mounting clips on the back of the tickers.
2. Hang each section (refer to the appropriate following subsection).
3. Refer to Section 3 for routing power and signal to each section.
4. Slide the sections together.
5. Slide the splice bar over the joint(s) between the displays.
6. Tighten the screws (provided in the splices) using a
3 /
16
″ hex wrench.
Hanging Mount
Reference Drawings:
Mounting Drawing, Ceiling, KE-1010 ............................Drawing A-118572
Splice bars, provided by Daktronics, have 3/8
″-16 UNC holes that can be used to
secure the ticker displays from a ceiling or other overhead structure. Use the middle
hole only when using the splice bars for mounting. To hang a ticker, refer to
Drawing A-118572 and the following instructions:
1. If it has not already been done, unpack the display and check for any
damage that may have occurred during shipping.
2. Determine and mark the locations where the ceiling mounting supports will
attach to the overhead structure. The supports, when installed, should form
a 90-degree angle with the top of the display (refer to Drawing A-118572).
Daktronics does not provide the ceiling mounting supports.
3. Install the supports. Qualified personnel must approve the ceiling mounting
supports. Daktronics is not responsible for ceiling mounting.
4. Secure the splice bars to the supports.
5. Carefully hang each display by fitting the channel on the top of the display
over the spice plates and slid it into place (refer to Drawing A-118572).
When multiple section displays are used, each joint between displays
must have hanging support.
Wall Mount
Reference Drawings:
Mounting Drawing, Wall, KE-1010-16 ...........................Drawing A-118222
Mounting Drawing, Wall, 15 Deg...................................Drawing A-119539
Mounting Drawing, Wall, 30 Deg. .................................Drawing A-119553
Wall Mounting, KE-1010-2-16x***-7.62 .........................Drawing A-210488
Detail, Horiz. Wall Mounting, KE-1010-24x***-7.62 ......Drawing A-214525
Shop Drawings .......................................................... Refer to Appendix A
Hang the master ticker using the mounting clips on the back of the display (refer to
Drawings A-118222, A-119539, A-119553, A-210488, and A-214525 for the type
of wall mounting used and the Shop Drawings for the location of the display’s
mounting clips). The clips fit into the slots in the mounting bracket.