Daktronics KE-1010-7.6-RG - Manual (Page 18)

The crimping tool is then used to crimp the RJ connector onto the cable. The RJ
connector is locked into a special socket in the tool. The stripped wire is inserted
into the RJ connector. Finally, the tool is squeezed like pliers to crimp the connector
onto the wire. This completes the installation of an RJ connector onto the wire.
Pin-Outs
Controller’s RS422 Jacks
The controller’s RS422 jacks have the following pin-out:
OUTPUT (J5)
RJ11 Function
1 N.C.
2 D2OUT-N
3 D2OUT-P
4 D2IN-N
5 D2IN-P
6 N.C.
INPUT (J4)
RJ11 Function
1 N.C.
2 D1OUT-P
3 D1OUT-N
4 D1IN-P
5 D1IN-N
6 N.C.
Controller’s Ethernet Jack
The controller’s input Ethernet jack has the following pin-out:
RJ45 Function
1 TX+
2 TX-
3 RX+
4 EPWR+
5 EPWR+
6 RX-
7 EPWR-
8 EPWR-
Signal Converter Jacks (J2 and J3)
The signal converter has two RS422 output jacks, with the following pin-out:
RJ45 Function
1 N.C.
2 CHGND
3 TX.A-N
4 TX.A-P
5 RX.A-N
6 RX.A-P
7 CHGND
8 N.C.
Electrical Installation 3-2