Daktronics KE-1010-7.6-RG - Manual (Page 23)

Electrical Installation
3-7
3.6 First Time Turn On
After all connections are made, it is time to turn on the display for the first time.
1. Plug the power cord(s) from the ticker(s) into a grounded 120 VAC single-
phase, grounded outlet.
2. Turn power ON to the display(s).
3. Carefully check the voltage between the hot lines and neutral. Normal
voltage range is between 120 VAC and 125 VAC.
4. If there are problems with the voltage, check with a local electrician or
power company.
5. The ticker will show a boot-up sequence each time power is applied. The
following information is displayed:
• DAKTicker by Daktronics
• ED10288
• REV X
• ADDRESS XX