Daktronics KE-1010-7.6-RG - Manual (Page 16)

Mechanical Installation 2-4
1. If it has not already been done, unpack the display and check for any
damage that may have occurred during shipping.
2. Determine and mark the locations where the mounting hardware will attach
to the wall. The top of the bracket should be located approximately ½
″
below the top of the display. There are hardware attachment points every 1
″
along the mounting brackets (refer to Drawing A-118222, A-119539, A-
119553, A-210488, and A-214525 and the Shop Drawings). Daktronics
does not provide the mounting hardware.
3. Install the mounting bracket(s). Be sure the bracket is mounted to
sufficiently support the weight of the display. Have all mountings
inspected by a qualified structural engineer.
4. Set the display on the wall-mounted bracket. The bracket fits onto the wall
mounting clips as shown in the reference drawings.