Daktronics KE-1010-7.6-RG - Manual (Page 14)

2.2 Display Mounting
Reference Drawings:
Shop Drawings...........................................................Refer to Appendix A
It is the customer’s responsibility to ensure that the installation will meet local
standards. The mounting hardware must be capable of supporting all components to
be mounted. The support structure design is critical and should be done only by a
qualified individual.
Daktronics recommends either a wall mount or hanging mount method. Remember
to have all mounted displays inspected by a qualified structural engineer.
Daktronics is not responsible for the installations or the structural integrity of
support structures done by others.
Refer to the Shop Drawings for display dimensions and approximate weights.
If the ticker is built using more than one section, it uses a “master-echo”
configuration to relay signal. Some additional steps are required when mounting this
type of display. These steps are indicated as needed. Refer to the appropriate
subsection for details.
In summary, to install the ticker you must:
1. Hang the mounting brackets (if wall mount display), or install the ceiling
mounting supports.
2. Remove the end caps on the connecting end of the master ticker if you are
using the master-echo configuration.
3. Connect the power cord(s), connect signal cable to master and hang the
master ticker display(s) on the bracket or from ceiling mounts. Refer to
Section 3 for power and signal information.
4. Hang the echo sections, and then attach power and connect signal (ribbon
cable) from the master display to the echo section(s).
5. Secure the ticker sections (master-echo configuration) using the splice bars.
Assembling Master-Echo Configuration Tickers
The echo sections are shipped without end caps. Remove the left outer end cap from
the “master” ticker and attach it to the left-most “echo” ticker (refer to
Figure 5 ).
Figure 5: Master-Echo Installation Detail
Mechanical Installation 2-2