Daktronics ST-2000 Tuff Sport & ColorSmart LED Scorer’s Table - Manual (Page 17)

Troubleshooting 11
Problem Possible Cause Solution/Items to Check
Scoreboard works, but some
digits do not light
Bad digit or driver (see solution above)
Incorrect sport code (see solution above)
Incorrect driver address (see solution above)
Wrong console controlling
scoreboard
Another console’s radio signal could
be transmitting to the scoreboard.
Radio interference
There may be other radio
transmissions in the area that
overpower the console. If it is not
possible to disable the interfering
device, It may be necessary to run a
wired signal connection instead.
3.2 Component Locations & Access
Daktronics scorer‟s tables are accessible both from the front by removing the individual digit
panels and through the rear by removing the access panels.
Rear Access
To access components through the rear, loosen the six screws securing the access panel and
lift it off of the keyholes (Figure 9).
Front Access
Digit panels are typically held in place by two screws. To remove a digit, unfasten the screws
and carefully lift the unit from the display. The signal harness can then be disconnected from
the back of the digit to access the internal components.
Figure 9: Component Locations (counter top and legs removed to show detail)