Comtech EF Data CSAT-6070 - Manual (Page 47)

50 Watt Model C-Band Transceiver Revision 0
Installation MN/CSAT607050.IOM
Figure 2-21. LNA Switch Kit,
AS/0438
1. Refer to Table 2-7, Figure 2-
11, Figure 2-12 and Figure 2-
21
2. Remove all protective tape
from switch and keep it
clean.
3. Position Low Noise Amplifiers (LNAs) and gasket (11) on Port 2 and Port 4
of switch (5).
4. Secure each LNA with 8 bolts (7), lock washers (8) and flat washers (12).
(See Figure 2-21.)
5. Position adapter (3) and gasket (11) on Port 3 and secure with 10 bolts (7),
lock washers (8), and flat washers (12).
6. Place termination (10) on threaded part of Adapter (3)
IMPORTANT
Ensure that the OUTPUT flange of the filter is against switch (5).
7. Position filter (4), gasket (11), and Support Bracket (Figure 2-12, AS/0502)
on Port 4 of switch (5) and secure with 8 bolts (3), lockwashers (2), and flat
washers (1) from AS/0502 kit, and use 2 bolts (7, Figure 2-11), lockwashers
(8), and flat washers (12) from AS/438 kit.
8. Set assembly aside for later installation.
2-23