Comtech EF Data CSAT-6070 - Manual (Page 31)

50 Watt Model C-Band Transceiver Revision 0
Installation MN/CSAT607050.IOM
1. Place unistrut brackets (1, Figure 2-1) on a flat surface.
2. Slide two springnuts (9) into the each channel of the unistrut brackets.
3. Fasten two pipe blocks (11) loosely to the springnuts using two bolts (6), two
flat washers (7), and two splitlock washer (8).
Figure 2-4. Preparing the Pole Bracket
4. Position unistrut brackets (1) with pipe blocks (11) against the mounting
pole, slide the pipe blocks (11) until they contact the mounting pole.
5. Ensure the pipe blocks (11) are centered to the unistrut brackets (1). Tighten
the hardware.
Figure 2-5b Looking down
Figure 2-5a. Installing the Pole Bracket
2-7