15 c, Snmp t, 16 c – Comtech EF Data CiM-25/9000 User Manual
Page 50
CiM-25/9000 IP Enabled M&C
Rev. 1
Operation
CD/CIM259000.IOM
32
Query Format:
!PT ?
Response:
!PT
Notes:
1. The default port is set to 80.
2. Changes made via this command do not become active until the user has sent
a !EE command to commit the changes to EEPROM of the CiM-25
3.5.1.15 C
HANGE
SNMP T
RAP
A
DDRESS
Using the !TP command, the Administrator can set the SNMP Trap Address. The
command protocol for this command is as follows:
Format:
!TP
Response:
Command Successful
Note: An IP Address of 0.0.0.0 disables the trap
Query Format:
!TP ?
Response:
!TP
Note: Changes made via this command do not become active until the user has sent a !EE
command to commit the changes to EEPROM of the CiM-25
3.5.1.16 C
HANGE
SNMP T
RAP
C
OMMUNITY
Using the !TC command, the Administrator can set the SNMP Trap Community. The
command protocol for this command is as follows:
Format:
!TC
Response:
Command Successful
where
Query Format:
!TC ?
Response:
!TC
Note: Changes made via this command do not become active until the user has sent a !EE
command to commit the changes to EEPROM of the CiM-25.