Comtech EF Data turboIP v4.0 - Manual (Page 45)

turboIPv4.0 Revision 6
Configuring turboIP ™ MN/TURBOIP.IOM
4–17
WEB Menu
Menu Description
Acceleration Set LAN and WAN Transmission Rates
Set WAN Maximum Transfer Unit (MTU)
Turn Compression On/Off
Set Congestion Control to Per-Connection or Rate Pacing
Interface Enter Management IP Address and subnet mask
Set LAN/WAN port Link Setting
Display LAN/WAN MAC address and Link Status
Routes Add, adjust, or delete routes from system routing table
Route entries are only required for remote network access to
the turboIP.
Selective Acceleration
Rules
Stats
Add, move, edit, and delete TCP/UDP QoS/Acceleration rules
Monitor statistics by priority
Each rule has the following variables - Source IP
address/Mask, Destination IP address/Mask, Protocol, Source
Port, Destination Port, Priority, Bandwidth, Acceleration
ON/OFF, and Status.
Administration Menu
Configuration
Event Log
Stats
Displays System Status for turboIP features – easyConnect,
FailToWire, Event Logging, Compression, SNMP, SSH
Interface
Displays System Up Time, turboIP Version, Unit ID
Used to administer the system functions – Reboot, Shutdown,
Upgrade
Enable Logging, View or Clear Event Log
Display/Reset System Statistics – Avg. Compression Ratio,
Session Statistics, WAN and LAN Statistics
Note: The Web interface Administration menu does not
support the following functions - Restore Defaults, Changes to
User Accounts or Password, and Reset System Time. These
functions are restricted to the CLI or SSH serial interface.