Comtech EF Data turboIP v4.0 - Manual (Page 103)

turboIPv4.0 Revision 6
Sample Configuration MN/TURBOIP.IOM
7-5
The following table defines the configuration settings for each turboIP.
Configuration Parameter Hub turboIP Remote turboIP (1 & 2)
WAN Transmission Rate 15 Mbps (equal to the total
TX data rates of Hub
modems, 8 + 5 + 2 Mbps) 1 Mbps (equal to the TX data
rate of Remote modem.
Congestion Control Rate Pacing Rate Pacing
Selective Acceleration Selective Acceleration Rules
are required to limit the
bandwidth for all of the traffic
destined for a particular
Remote site. The BW limit
would be equal to the TX data
rate of Hub modem that is
linked to the particular site 8
Mbps for Site 1, 5 Mbps for
Site 2, and 2 Mbps for Site 3. No Selective Acceleration
Rules are required. Rules
could be added to prioritize or
set BW limits on types of
traffic.
Route Table No Route Table entries are required. Routes could be added
to allow remote access from outside of LAN subnet.