Comtech EF Data turboIP v4.0 - Manual (Page 100)

turboIPv4.0 Revision 6
Sample Configuration MN/TURBOIP.IOM
7-2
7.2 Point-to-Point Configuration
Internet
WAN
LAN
Remote Site
WAN
LAN
15
M
b
p
s 20
48
k
bp
s
Hub Site
15
M
b
p
s 20
48
k
b
p
s
This configuration is a typical example where turboIPs’ are used to maximize the TCP
throughput in a Point-to-Point system. Note the turboIPs’ are placed so that all TCP traffic
between the Remote and the hub must pass through the turboIP. The following table defines the
configuration settings for each turboIP.
Configuration Parameter Hub turboIP Remote turboIP
WAN Transmission Rate 15 Mbps (equal to the TX
data rate of Hub modem) 2048 kbps (equal to the TX
data rate of Remote modem)
Congestion Control Rate Pacing Rate Pacing
Selective Acceleration
No Selective Acceleration Rules are required. Rules could be
added to prioritize or set BW limits on any type of traffic.
Route Table No Route Table entries are required. Routes could be added
to allow remote access from outside of LAN subnet.