Comtech EF Data turboIP v4.0 - Manual (Page 44)

turboIPv4.0 Revision 6
Configuring turboIP ™ MN/TURBOIP.IOM
4–16
4.5 M
ENUS AND
F
UNCTIONS
- S
UMMARY
The menus and functions that comprise this section are:
CLI Menu
Menu Description
Configure Interfaces
Menu Enter Management IP Address and subnet mask
Turn WEB Interface On/Off
Turn SSH Interface On/Off
Set LAN/WAN port Link Setting
Display LAN/WAN MAC address and Link Status
Gateway Menu Set LAN and WAN Transmission Rates
Set WAN Maximum Transfer Unit (MTU)
Turn Compression On/Off
Set Congestion Control to Per-Connection or Rate Pacing
Routing Menu Add, adjust, or delete routes from system routing table
Route entries are only required for remote network access to
the turboIP.
SNMP Menu Set SNMP subsystem On/Off
Set SNMP system variables such as, System Information,
Community Strings, and Trap Destination.
Selective Acceleration
Menu Add, move, edit, and delete TCP/UDP QoS/Acceleration rules
Monitor statistics by priority
Each rule has the following variables - Source IP
address/Mask, Destination IP address/Mask, Protocol, Source
Port, Destination Port, Priority, Bandwidth, Acceleration
ON/OFF, and Status.
Administration Menu Displays System Status for turboIP features – easyConnect,
FailToWre, Event Logging, Compression, SNMP, Web
Interface, SSH Interface
Displays System Up Time, turboIP Version, Unit ID
Used to administer the system functions – Restore Defaults,
Reboot, Shutdown, Upgrade, Reset System Time, Change
Password, Add User, Delete User
Enable Logging, View or Clear Event Log
Display/Reset System Statistics – Avg. Compression Ratio,
Session Statistics, WAN and LAN Statistics