Comtech EF Data MIDAS 4 Software Installation User Manual
Page 23
MIDAS 4 Software Installation Guide, Rev.4
System Preparation
2–3
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
o
o
f
f
F
F
A
A
S
S
T
T
C
C
O
O
M
M
E
E
S
S
C
C
C
C
_
_
P
P
C
C
I
I
Install the FASTCOM ESCC_PCI card into a rear slot of the Controller Server
as follows:
1. Open the FASCTCOM card package, ensuring all ESD precautions are
observed.
2. Install the FASTCOM card in the PCI slot and plug in to the motherboard
(see Figure 2-1).
3. Connect supplied Y-Cable as follows:
a. Connect the supplied-cable base connector to the FASTCOM card.
b. Connect supplied-cable Port 1 connector to the Comtech EF Data supplied
EIA-422 cable from SNM-1001 Modem (P/N CA/5684).
c. Cable Port 2 connector is not connected.
4. Connect 9-pin EIA-232 cable from Controller Server COM 1 port to SNM-1001
Remote port (J6).
a. If non-redundant SNM-1001, the following remote settings are required:
EIA-232
19.2 Baud rate
8N1
5. Connect 9-pin EIA-232 cable from Controller Server COM 2 port to SNM-1002
Remote port (J6).
6. Connect 25-pin pre-programmed dongle to Controller Server 25-pin I/O port.
Figure 2-1. Installation of FASTCOM Card