Compuprint 9070 User Manual
Page 78
73
Adjusting the Tear-Off Position
F2 JAM SENS. Y
(PRT9071 model)
or
F1 JAM SENS. Y (if 6 pin Front1 Push Tractor is installed)
or
MENU ENGLISH
↑
TEAR ADJUST: - 30
→ or ←
TEAR ADJUST: ...
→ or ←
TEAR ADJUST: +360
→ or ←
↓
CUT ADJUST (if the cutter option is installed)
or
BUZZER YES
TEAR ADJUST: xxxx
These values adjust the distance between the Tear-Off Perforation and
the Tear-Off Bar. The values correspond to 1/180 inch units, i.e. the
tuning ranges between -1/6 and 2 inch. 0 is the default value.
See also “How to Use the Tear-Off Function”, later in this Chapter.