Compuprint 4247-L03 Programmer Manua - Manual (Page 111)

This command sets multiple print attributes depending on the n parameter as follows:
Bit=1 Bit=0
Bit 7 underline –
Bit 6 – –
Bit 5 subscript superscript
Bit 4 1/4 size –
Bit 3 double height –
Bit 2 double width –
Bit 1 half size –
Bit 0 rotate print normal print
FS v n
Sets - Cancels line drawing character connection mode.
ASCII Code FS v n
Hexadecimal Value X'1C' X'76' n
Decimal Value 28 118 n
When n=1, this command allows the printer to fill the horizontal and vertical breaking point of a table that
is being printed. This is accomplished by adding special horizontal or vertical line drawing characters.
These characters are in the following address ranges: X'A854' to X'A970', X'A9A4' to X'A9A7', X'A9B0' to
X'A9BF'.
When n=0, the function is cancelled.
FS c nl nh
Sets the HMI (Horizontal Motion Index)
ASCII Code FS c nl nh
Hexadecimal Value X'1C' X'63' nl nh
Decimal Value 28 99 nl nh
This command defines the horizontal motion (space) occupied by a full size character. The horizontal
motion is specified in n/180 of inch and its value is: HMI = ((nh * 256) + nl) * 1/180".
FS b n
Sets the DBCS standard line.
ASCII Code FS b n
Hexadecimal Value X'1C' X'62' n
Decimal Value 28 98 n
This command defines the position of the base line of the character.
n=0 The base line is the current print position.
n=1 The base line is 24/180 of and inch below the current position.
Chapter 5. Epson LQ1600K Emulation 95