Compuprint 4247-L03 Programmer Manua - Manual (Page 110)

FS x n
Sets print quality level for the DBCS font set.
ASCII Code FS x n
Hexadecimal Value X'1C' X'78' n
Decimal Value 28 120 n
n=0 set Draft (high speed)
n=1 set Quality (low speed)
There are four type of print quality level, two for Draft mode and two for Quality mode. A specific Menu
Item (see the User Manual) assigns which of the two Draft modes is activated when the parameter n is
equal to 0 and which of the two Quality modes is activated when the parameter n is equal to 1.
n=0 Activate the NLQ or LQ mode as specified with the “SW Qual-Level” menu item.
n=1 Activates the Draft or Best Draft mode as specified with the “SW Qual-Level” menu item.
FS 2 a 1 a 2 n 1 ... n 72
Sets user-defined character (DownLoading).
ASCII Code FS 2 a 1 ... n 72
Hexadecimal Value X'1C' X'32' ...
Decimal Value 28 50 ...
a 1 a 2 = The address of the GB18030 character set where the character to download has to be allocated.
The address must be included in the following ranges: X'AAA1' to X'AFFE', X'F8A1' to X'FEFE', X'A140' to
X'A7A0'.
n 1 ... n 72 = The shape of the character in dots as defined over a matrix of 24vx24h dot matrix.
Three bytes in vertical are equivalent to the 24 dots of any column; when multiplied by 24 columns it is
equal to 72 bytes in total per character.
FS ! n
Sets multiple print attribute at once.
ASCII Code FS ! n
Hexadecimal Value X'1C' X'21' n
Decimal Value 28 33 n
94 Programmer Manual