Compuprint 4247-L03 Programmer Manua - Manual (Page 106)

FS SO
Sets double width mode.
ASCII Code FS SO
Hexadecimal Value X'1C' X'0E'
Decimal Value 28 14
All of the characters following this command are printed horizontally, enlarged two times. This print mode
is reset by DC4, FS DC4 commands and automatically resets at the end of the line with a line terminator
(LF, FF, CR, ...)
FS DC4
Resets double width mode.
ASCII Code FS DC4
Hexadecimal Value X'1C' X'14'
Decimal Value 28 20
This command resets the double width print mode previously set by the FS SO command.
FS W n
Sets - Resets quadruple print mode.
ASCII Code FS W n
Hexadecimal Value X'1C' X'57' n
Decimal Value 28 87 n
Range
n = 1 set
n = 0 reset
This command sets (n=1) double width and double height print mode. The character dimension will be 2x2
the normal dimension.
With n=0 the double width/height print mode is reset.
FS J
Sets 90 degrees counterclockwise character rotation.
ASCII Code FS J
Hexadecimal Value X'1C' X'4A'
Decimal Value 28 74
Printable data after this command are rotated 90 degrees counterclockwise. This mode is also called
vertical print.
90 Programmer Manual