Compuprint 3056 - Manual (Page 43)

34
Using paper out path guide
It is convenient to change paper out path using the paper out path guide. It’s
shown below:
Set the position of the tractor
To change the position of the tractor, you should remove it from the former
position. Remove the tractor by pressing the tractor’s locking tabs and lifting it
up.
Install the front push tractor
1. Make sure the printer is powered off. Open the cover of the front paper load
location, and remove the front single sheet paper guide by grasping the
handles on both sides of sheet paper guide.
2. Insert tractor into the mounting slot of the printer by pressing the tractor’s
locking tabs
The factory setting of path selection lever is in rear location. In order to
load the paper smoothly into the printer, make sure the continuous paper is
properly loaded in the tractor. If you want to load paper from the bottom
location, use printer shelf, there is a hatch to load paper smoothly.