ChamSys MagicQ Software Change Log - Manual (Page 60)

MagicQ Software Change Log 46 / 121
23.2 Bug Fixes
Fixed problem with receive of MIDI notes on different MIDI channels. MIDI Automs that specified a particular MIDI channel
would not trigger correctly. MIDI notes using the miditable.txt would also not trigger if a "Requested Chan Only" was set in
Setup, View Settings, MIDI, MIDI In type. #0007427
Fixed problem in recent betas with Patch, Multiply which would incorrectly output values between 128 and 254.
Reduced MagicHD OpenGL requirement from 3.3 to 3.2 for Mac OS 10.7 and 10.8. #0007558
Fixed problem on Mac and Linux 64 bit PC systems with Cue delay times and restarting of Cues after pausing. Incorrect values
could be output during the fade phase. #0007116 #0007417, #0005911
Recording a position palette and then recording a Cue without reselecting the recorded palette causing the cue to have no link to
the palette. #0006972, #0005937
Mouse pan/tilt did not work in recent betas. #0000149, #0006874, #0006028, #0001469, #0007562
Shortcut of SHIFT + DBO shutting down console removed from Windows/Mac/Linux PC systems #0007059
Reset Wings causes MQ40/60/70 to enter PC mode #0006192
Graphical improvements - new toolkit #0006857, #0007519, #0007432, #0006727, #0007324, #0007340, #0006991, #0006543,
#0005349, #0007604
Support for setting direct values to soft buttons in the Programmer and Cue windows. #0006469
Fixed reset when pressing Cancel during CMV conversion selection. #0007566
Fixed problem with selecting FX from FX window whereby if the FX had exactly the same fixtures and parameters the output
would not show the change #000760
Fixed problem with tap to time using "S+Go", "S+Flash", "S + Stop" on Cue Stacks with multiple steps #0006767
Page right/left doesn’t work on head editor #0000336
Editing a Waveform FX adding extra attributes caused a reset #0006813
Clear selected didn’t work on sub selected fixtures #0005154: