Glossary, Chapter 7 – Dynalink RTA770 User Manual
Page 99

Chapter 7: Glossary
87
Chapter 7
Glossary
ARP
(
Address Resolution Protocol )
ARP
is a TCP/IP protocol for mapping an IP address to a physical machine address that is
recognized in the local network, such as an Ethernet address. 
A host wishing to obtain a physical address broadcasts an ARP request onto the TCP/IP 
network. The host on the network that has the IP address in the request then replies with 
its physical hardware address. 
Inverse ARP (In-ARP), on the other hand, is used by a host to discover its IP address. In 
this case, the host broadcasts its physical address and a RARP server replies with the host's 
IP address. 
DHCP (Dynamic Host Configuration Protocol)
When operates as a DHCP server, the ADSL Router assign IP addresses to the client PCs on 
the LAN. The client PCs “leases” these Private IP addresses for a user-defined amount of 
time. After the lease time expires, the private IP address is made available for assigning to 
other network devices. 
The DHCP IP address can be a single, fixed public IP address, an ISP assigned public IP 
address, or a private IP address. 
If you enable DHCP server on a private IP address, a public IP address will have to be 
assigned to the NAT IP address, and NAT has to be enabled so that the DHCP IP address 
can be translated into a public IP address. By this, the client PCs are able to access the 
Internet. 
LAN (Local Area Network) & WAN (Wide Area Network)
A LAN is a computer network limited to the immediate area, usually the same building or 
floor of a building. A WAN, on the other hand, is an outside connection to another network 
or the Internet. 
The Ethernet side of the ADSL Router is called the LAN port. It is a twisted-pair Ethernet 
10Base-T interface. A hub can be connected to the LAN port. More than one computers, 
such as server or printer, can be connected through this hub to the ADSL Router and 
composes a LAN. 
The DSL port of the ADSL Router composes the WAN interface, which supports PPP or RFC 
1483 connecting to another remote DSL device. 
