Dynalink RTA770 - Manual (Page 29)

Chapter 3: Configuration
17
For Windows XP
1. From the Start menu, point to Control
Panel and then click Network and
Internet Connections.
2. Click Network Connection and then
click Properties.
3. Click Network Connection and then
click Properties.3. On the General tab,
check out the list of installed network
components.
Option 1: If you have no TCP/IP
Protocol, click Install.
Option 2: If you have TCP/IP Protocol,
go to Step 6.
4. Highlight Protocol and then click Add.
5. Click Internet Protocol(TCP/IP) and
then click OK.
6. On the Local Area Connection
Properties window, highlight Internet
Protocol (TCP/IP) and then click
Properties.
7. Under the General tab, enable Use the
following IP address. Enter the IP
address: 192.168.1.x (x is between 2
and 254), Subnet Mask: 255.255.255.0
and Default gateway: 192.168.1.1. Then
click Ok.