Bronkhorst Mini CORI-FLOW - Manual (Page 23)

BRONKHORST CORI-TECH B.V.
2.14 Electromagnetic compatibility
Conditions for compliance with EMC requirements
All instruments described in this manual carry the CE-mark.
Therefore they have to comply with the EMC requirements, as they are valid for these instruments.
However compliance with the EMC requirements is not possible without the use of proper cables and
connector/gland assemblies.
For good results Bronkhorst Cori-Tech B.V. can provide standard cables. Otherwise follow the guidelines as
stated below.
1. Connector mini CORI-FLOW
Note:
When connecting the system to other devices (e.g. to PLC), be sure that the integrity of the shielding is not
affected. Do not use unshielded wire terminals.
1. For FLOW-BUS S(F)TP data (patch) cable connection to M12 connectors follow the instructions of the
supplier. It is important to use shielded twisted pair cables and shielded RJ45 modular jack connectors.
2. For PROFIBUS-DP, Modbus or DeviceNet data cable connections follow the instructions of the cable
suppliers for the specific field-bus system.
9.17.050 page 23