BECKHOFF BC3150 - Manual (Page 63)

Safety Instructions
Fieldbus Components 61
Creating a boot project
Approximately 250 kB of flash are available.
For creating a boot project
•
on the Bus Terminal Controller of BX-Series app. 250 kByte of flash are available
•
on the Bus Terminal Controller of BCxx50-Series app. 48 kByte of flash are available
PLC Control
After logging in, a boot project can be created in TwinCAT PLC Control.
•
Opening a PLC project
•
Selecting the target system (or selection the serial interface)
•
BX/BCxx50 login
•
Creating the boot project (Online\Create boot project)
Once a valid boot project is present on the BX/BCxx50 controller, the green PLC LED is on.
At the Bus Terminal Controller of BX-Series the PLC LED will flash orange during the creation of the boot project. If
no boot project is available on the BX the PLC LED shines orange.
Deleting a boot project
A boot project can be deleted from the BX/BCxx50. The following steps must be followed:
•
Opening the project
•
BX/BCxx50 login
•
Deleting the boot project (Online\Delete boot project)
Once the boot project was deleted, the PLC LED will be orange.
Note
After an online change, the boot project is still the old project. To use the current project
(after the online change) as the boot project, the boot project has to be recreated.
Bypassing the start of the boot project*
At the Bus Terminal Controller of BX-Series the start up of an existing boot project can be avoided by pressing the
Navi switch during booting. This will not delete the boot project. The project can still be used when the controller is
switched on again.
* from version 0.85