BECKHOFF BK5200 - Manual (Page 22)

BK5200, BK5210, LC5200 DeviceNet
22 BK52x0
Configuring the Bus Coupler
Setting the DIP switches
Set all the DIP switches to the desired configuration before you switch on
the Bus Coupler. Switches 7 and 8 are used to set the baud rate, as shown
in the following table.
Setting the baud rate
Setting baud rates 1 2 3 4 5 6 7 8
125 kbaud off off
250 kbaud on off
500 kbaud off on
(Default) 125 kbaud on on
Setting the MAC ID
DIP switches 1 to 6 are used to set the MAC ID, where switch 1 is the
lowest value bit 20, and switch 6 the highest value bit 25. The bit is set
when the switch is ON.
You can select the MAC ID from the range 0 to 63.
Switch on the Bus Coupler When you have set all the DIP switches to the desired configuration you
can switch on the Bus Coupler. Any changes you make to the switches
while the system is in operation will have no effect until the next time it is
switched on.