Becker TRAFFIC ASSIST Z217 - Manual (Page 23)

23
GENERAL OPERATION >>>
> D
> GB
> F
> I
> E
> P
> NL
> DK
> S
> N
> FIN
> TR
> GR
> PL
> CZ
> H
> SK
On the windscreen
The unit holder can be attached directly
to the windscreen using the suction mech-
anism.
> Press the carrier plate onto the four re-
taining lugs of the unit holder.
> Select a suitable spot to attach.
> Unscrew the fastening screws
and
a little.
> Press the base with its suction sur-
face against the windscreen. Turn
the unit holder such that the carrier
plate is positioned roughly in the de-
sired viewing direction.
> Press the lever down.
The holder has attached itself firmly to the
windscreen. It can now be adjusted with
precision. In order to remove it, operate
the lever again.
Adjusting the unit holder’s posi-
tion
> Loosen the fastening screws and
until the carrier plate can be moved
without using excessive force.
> Move the carrier plate to the re-
quired position and hold it in this posi-
tion.
> Tighten the fastening screws and
sufficiently so that the Traffic Assist
is held securely in place when the vehi-
cle is in motion.
Attaching the Traffic Assist
> Position the Traffic Assist, with the at-
tachment point on the bottom of the
housing, onto the carrier plate
.
> Without using excessive force, press the
Traffic Assist onto the carrier plate .
The Traffic Assist locks into place.
Removing the Traffic Assist
Press the button on the top of the car-
rier plate . This unlocks the Traffic As-
sist which can be removed from the carrier
plate.
Switching the Traffic Assist
on/off
Using the On/Off switch you can
switch the Traffic Assist on or off com-
pletely.
Using the button
on the top of the
Traffic Assist you can place the unit in
sleep mode or switch it on again from
sleep mode. 4
5
2
1
3
3
4 5
6
6
4
5
6
6
7
6
1
2
1
2